Copper Mountain Technologies S2 Series - Sens:corr:coll:ckit:ord:open; Sens:corr:coll:ckit:ord:sel

S2VNA and S4VNA SCPI Programming Manual
223
SENS:CORR:COLL:CKIT:ORD:OPEN
SENSe:CORRection:COLLect:CKIT:ORDer:OPEN <port> , <numeric>
SENSe:CORRection:COLLect:CKIT:ORDer:OPEN? <port>
Description
Sets or reads out the number of the calibration standard of the
open type, used for the measurement of the specified port.
(command/query)
Target
Selected calibration kit
Parameter
<port> the number of the port from 1 to 2 (or 4)
<numeric> the number of the calibration standard
Out of Range
If the specified standard number is greater than the number of standards
in the kit, an error occurs. If the specified standard number is not the
open standard number, an error occurs.
Query Response
<numeric>
Equivalent Softkeys
Calibration > Cal Kit > Specify CLSs > Open Port x (Row)
SENS:CORR:COLL:CKIT:ORD:SEL
SENSe:CORRection:COLLect:CKIT:ORDer:SELect <numeric>
SENSe:CORRection:COLLect:CKIT:ORDer:SELect?
Description
The subclass used to specify classes of calbration standards by the
commands SENSe<Ch>:CORRection:COLLect:CKIT:ORDer:XXXX.
Target
Selected calibration kit
Parameter
<numeric> the subclass number from 1 to 8
Query Response
<numeric>
Equivalent Softkeys
Calibration > Cal Kit > Specify CLSs > Subclass n (Column)