Copper Mountain Technologies S2 Series - Page 421

421
213
"Init ignored"
214
"Invalid limit data"
215
"Invalid segment data"
216
"Invalid standard type specifier"
217
"Invalid conversion specifier"
218
"Invalid gating shape specifier"
219
"Invalid gating type specifier"
220
"Parameter Error"
221
"Invalid port index"
222
"Data out of range"
223
"No Calibration Measurement Data"
224
"Illegal parameter value"
225
"Cal Kit Definition Error"
226
"Differ Forward and Reverse Thru"
227
"Differ Forward and Reverse TRL Thru"
228
"Differ Forward and Reverse Line"
229
"TRL Match Standard is not Load Type Standard"
230
"ACM Auto-Orientation Error"
231
"ACM Orientation Settings Error"
232
"AutoCal Execution Error"
233
"ACM Frequncy Settings Error"
234
"ACM Characterization Error"
235
"Frequency Range Exceeds ACM Characterization
Frequency Range"
236
"AutoCal Module Reading Error"
237
"Incorrect set of measured parameters"
238
"Calibration Execution Error"
239
"TRIG:SING interrupted"