562
Upgrade and Maintenance Manual TX2560 M2 / RX2560 M2
iRMC-related status signals
I
For further information please refer to section "Updating or recovering
the iRMC" on page 119.
HDD prefailure detection
Depending on your hardware configuration HDD prefailure will be supported.
The requirements are:
– iRMC Firmware 7.14 or later
– supported OOB system
– dedicated RAID controller
ID indicator
Global error
indicator
Description
blue flashing off
A remote connection has been
established. Local VGA output has been
disabled during the remote session.
blue flashing orange flashing
An emergency flash of the iRMC firmware
is in progress.
Not supported RAID controllers
D2616/MegaRAID SAS 9280-8e MegaRAID SAS9285CV-8e
D3116/D3116C D2607
Table 8: Not supported RAID controllers
To Next Page
Loading...
