RM0016 16-bit advanced control timer (TIM1)
Doc ID 14587 Rev 8 203/449
Note: The state of the external I/O pins connected to the OCi channels depends on the OCi
channel state and the GPIO registers.
0
0
x
(2)
xx
Output disabled (not driven by the timer)
0
0
0
1
Off state (output enabled with inactive state)
Asynchronously: OCi = CCiP and OCiN = CCiNP
Then if the clock is present: OCi = OISi and OCiN = OISiN after
a deadtime, assuming that OISi and OISiN do not correspond
with OCi and OCiN in active state
1
1
1
1. Never set CCiE = CCNiE = 0 when the channel is used. When the channel is not used, program CCiP = CCiNP = OISi =
OISiN = 0 otherwise.
2. Don’t care
Table 38. Output control for complementary OCi and OCiN channels with break feature
(1)
Control bits Output states
MOE OSSI OSSR CCiE CCiNE OCi OCiN
To Next Page
Loading...
Need help?
General
