NETGEAR M4300 - Configure a DHCP L2 Relay Interface

Configure System Information
104
M4300 Series and M4300-96X Fully Managed Switches User Manual
4. Click the Login button.
The System Information page displays.
5. Select System > Services > DHCP L2 Relay > DHCP L2 Relay Global Configuration.
6. Select the Admin mode Disable or Enable radio button.
For global configuration, this enables or disables the DHCP L2 Relay on the switch. The
default is Disable.
7. For VLAN configuration, VLAN ID shows the VLAN ID configured on the switch.
a. Use Admin mode to enable or disable the DHCP L2 Relay on the selected VLAN.
b. Use Circuit ID mode to enable or disable the Circuit ID suboption of DHCP
Option-82.
c. Use Remote ID String to specify the Remote ID when Remote ID mode is enabled.
8. Click the Apply button.
Your settings are saved.
The pagination navigation menu functions as follows:
- Rows per page. Select how many table entries are displayed per page. Possible
values are 20, 50, 100, 200, and
All. If you select
All, the browser might be slow to
display the information.
- <. Display the previous page of the table data entries.
- >. Display the next page of the table data entries.
Configure a DHCP L2 Relay Interface
 To configure DHCP L2 Relay:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.