Configure Switching Information
196
M4300 Series and M4300-96X Fully Managed Switches User Manual
12. In the DSCP Value field, configure the Voice VLAN DSCP value for the port.
The valid range is 0 to 64. The default value is 0.
The Operational State field displays the operational status of the voice VLAN on the
interface.
13. Click the Apply button.
Your settings are saved.
Configure GARP Switch Settings
Note: It can take up to 10 seconds for GARP configuration changes to take
effect.
To configure GARP switch settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching> VLAN >
Advanced > GARP Switch Configuration.
6. Select the GVRP Mode
Disable or Enable radio button.
This selects the GARP VLAN registration protocol administrative mode for the switch.
The factory default is Disable.
7. Select the GMRP Mode Disable or Enable radio button.
This selects the GARP multicast registration protocol administrative mode for the switch.
The factory default is Disable.
8. Click the Apply button.
Your settings are saved.
To Next Page
Loading...
