Routing
309
M4300 Series and M4300-96X Fully Managed Switches User Manual
14. Specify the router advertisement Life Time Interval sent from the interface.
This value must be greater than or equal to the maximum advertisement interval. 0
means do not use the router as the default router.
The range of router life time is 0 to
9000. The default is 1800.
15. In the Adv NS Interval field, specify the retransmission time field of router advertisements
sent from the interface.
A value of 0 means the interval is not specified for the router. The range of the neighbor
solicit interval is 1000 to 4294967295. The default is 0.
16. In the Adv Reachable Interval field, specify the router advertisement time.
This is the amount of time allocated to consider the neighbors reachable after ND
confirmation. The range of reachable time is 0 to 3600000.
The default is 0.
17. Use the Adv Interval field to specify the maximum time allowed between sending router
advertisements from the interface.
The range of the maximum advertisement interval is 4 to 1800. The default value is 600.
18. In the Adv Other Config Flag list, select Enable or Disable to specify the router
advertisement other stateful configuration flag.
Default value of other config flag is Disable.
19. In the Adv Suppress Flag list, select to Enable or Disable router advertisement
suppression on an interface.
The default value of the suppress flag is Disable.
20. In the Destination Unreachables list, select to Enable or Disable the mode of sending
ICMPv6 destination unreachables on this interface.
If disabled, then this interface does not send ICMPv6 destination unreachables. By
default, the IPv6 destination unreachables mode is enabled.
21. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
IPv6 Prefix Configuration
Configure IPv6 prefix configuration:
1. Launch a web browser.
Table 111. IPv6 Advanced Interface Configuration
Field Description
Operational Mode Specifies the operational state of an interface. The default value is
Disable.
Link State Indicates whether the link is up or down.
To Next Page
