NETGEAR M4300 User Manual

Configure Switching Information
255
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the nonconfigurable information displayed on the page.
Configure an MVR Group
 To configure an MVR group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching > MVR >
Advanced > MVR Group Configuration.
6. Use the MVR Group IP to specify the IP address for the new MVR group.
7. Use the Count
to specify the number of contiguous MVR groups.
This helps you to create multiple MVR groups through a single click of the Add button. If
the field is empty
, then clicking the button creates only one new group.
The field is
displayed as empty for each particular group. The range is from 1 to 256.
8. Click the Add button.
The MVR group is added.
Table 91. Advanced MVR Configuration
Field Definition
MVR Max Multicast Groups The maximum number of multicast groups that MVR supports.
MVR Current Multicast Groups Displays the current number of MVR groups allocated.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)