NETGEAR M4300 - Reset All User Passwords to Their Default Settings

Maintenance and Troubleshooting
658
M4300 Series and M4300-96X Fully Managed Switches User Manual
4. Click the Login button.
The System Information page displays.
5. Select Maintenance > Reset > Factory Default.
6. Select the check box.
7. Click the Apply button.
A confirmation pop-up window opens.
8. Click Ye
s to confirm.
All configuration parameters are reset to their factory default values.
All changes you
made are, even if you issued a save.
Reset All User Passwords to Their Default Settings
 To reset all user passwords to their default settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Maintenance > Reset > Password Reset.
6. Select the check box.
7. Click the Apply button.
All user passwords are reset to their factory default values.