Configure Switching Information
181
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the Reset Configuration check box.
WARNING:
If you select this button and confirm your selection on the next
page, all VLAN configuration parameters are reset to their factory
default values.
7. Confirm your selection.
All VLANs, except for the default VLAN, are deleted. The factory default values are as
follows:
• All ports are assigned to the default VLAN of 1.
• All ports are configured with a PVID of 1.
• All ports are configured to an Acceptable Frame
Types value of Admit All Frames.
• All ports are configured with ingress filtering disabled.
• All ports are configured to transmit only untagged frames.
• GVRP is disabled on all ports and all dynamic entries are cleared.
Configure an Internal VLAN
The Internal VLAN section displays the allocation base and the allocation mode of internal
VLAN. The internal VLAN is reserved by a port-based routing interface and invisible to the
end user. Once these internal VLANs are allocated by the port-based routing interface, they
cannot be assigned to a routing VLAN interface.
To configure an internal VLAN:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.