Multicast Routing
428
M4300 Series and M4300-96X Fully Managed Switches User Manual
PIM protocol. A range of multicast addresses, currently 232.0.0.0/8 in IPv4 and FF3x::/32 in
IPv6, is reserved for SSM.
To configure PIM SSM settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> Multicast > PIM > SSM Configuration.
6. In the SSM Group
Address
field, enter the source-specific multicast group IP address.
7. In the SSM Group Mask field, enter the source-specific multicast group IP address
mask.
8. Click the Add button.
The source-specific group is added.
Configure PIM Interface
To configure the multicast PIM interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> Multicast > PIM > Interface Configuration.
To Next Page
Loading...
