Manage Device Security
527
M4300 Series and M4300-96X Fully Managed Switches User Manual
22. Select the Denial of Service UDP Port Disable or Enable radio button.
Enabling UDP Port DoS prevention causes the switch to drop packets with UDP source
port equal to UDP destination port. The factory default is Disable.
23. Click the Apply
button.
Your settings are saved.
Configure Access Control Settings
You can configure an access control profile and associate an access control rule with the
profile. The switch supports one access control profile only.
To complete set up a profile with a rule, follow the procedures that are described in the
following sections:
1. Configure an Access Control Profile on page 527
2. Configure Access Rule Settings for the Access Control Profile on page 529
Configure an Access Control Profile
To configure the access profile settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security
> Access
> Access Control > Access Profile Configuration.
To Next Page
Loading...
