Configure Switching Information
275
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure MRP Port Settings
You can configure the per-port MRP mode and timer settings. The timers control when and
how often various messages are transmitted on each interface.
To configure MRP port settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching> MRP > Advanced > Port Settings.
6. T
o configure one or more ports or LAGs, select the check box next to each port or LAG to
configure.
Y
ou can select multiple ports to apply the same settings to the selected interfaces.
7. In the MVRP Mode field, select Enable or Disable.
This specifies the administrative mode of Multiple VLAN Registration Protocol (MVRP) on
the interface. MVRP registers VLANs in the network, enabling automatic VLAN
configuration on the device.
8. In the MMRP Mode field, select Enable or Disable.
This specifies the administrative mode of Multiple MAC Registration Protocol (MMRP) on
the interface. MMRP allows the propagation of MAC address information in the network
and allows for the registration and deregistration of both individual MAC address
information and group MAC address membership.
9. Use the MRP Join Timer field to configure the
amount of time in centiseconds to wait for
JoinIn messages from other MRV participants after the interface sends a Join message.
To Next Page
Loading...
Need help?
General
