Manage Device Security
556
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the storm control settings:
• Select the Broadcast Storm Control All
Disable or Enable radio button.
This enables or disables Broadcast Storm Recovery mode on all ports. When you
specify Enable and the broadcast traffic on any Ethernet port exceeds the configured
threshold, the switch blocks (discards) the broadcast traf
fic. The factory default is
Enable.
• Select the Multicast Storm Control All Disable or
Enable radio button.
This enables or disables Multicast Storm Recovery mode on all ports. When you
specify Enable, and the multicast traffic on any Ethernet port exceeds the configured
threshold, the switch blocks (discards) the multicast traf
fic. The factory default is
Disable.
• Select the Unknown Unicast Storm Control All
Disable or Enable radio button.
This enables or disables Unicast Storm Recovery mode on all ports. When you
specify Enable, and the unicast traffic on any Ethernet port exceeds the configured
threshold, the switch blocks (discards) the unicast traf
fic. The factory default is
Disable.
7. Click the Apply button.
Your settings are saved.
Configure Storm Control for a Port
To configure storm control for a port:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security > T
raffic Control > Storm Control > Storm Control Interface
Configuration.
To Next Page
Loading...
