NETGEAR M4300 - Configure Ospfv3 Default Route Advertise Settings

OSPF and OSPFv3
379
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the Admin Mode Disable or Enable radio button.
If you select Enable, OSPFv3 is activated for the switch. By default, OSPFv3 is enabled.
You must configure a router ID before OSPFv3 can become operational. For more
information, see Configure the Routing IP Settings
on page 291.
Note: Once OSPFv3 is initialized on the router, it remains initialized until the
router is reset.
7. Enter the Router ID as a 32-bit integer in dotted-decimal format that uniquely identifies the
router within the autonomous system (AS).
To change the router ID, you must first disable OSPFv3. After you set the new router ID,
you must reenable OSPFv3 for the change to take ef
fect.
The default value is 0.0.0.0,
although this is not a valid router ID.
8. Click the Apply button.
Your settings are saved.
Configure OSPFv3 Default Route Advertise Settings
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing > OSPFv3 >
Advanced > OSPFv3 Configuration.