Configure Switching Information
256
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the nonconfigurable information displayed on the page.
Configure an MVR Interface
To configure an MVR interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching > MVR > Advanced > MVR Interface Configuration.
The status of each port displays.
6. Use Interface to select the interface.
7. Use Admin Mode to Enable or Disable MVR on a port.
The factory default is Disable.
8. Use T
ype to configure the port as an MVR
receiver port or a source port.
The default port type is none.
9. Use Immediate Leave to Enable or Disable the Immediate Leave feature of the MVR on
a port.
Table 92. MVR Group Configuration
Field Definition
Status The status of the specific MVR group.
Members The list of ports that participate in the specific MVR group.
To Next Page
Loading...
