NETGEAR M4300 - Configure a Link Dependency Interface

Configure System Information
149
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure a Link Dependency Interface
 To configure a link dependency interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Link Dependency > Link Dependency Interface Configuration.
6. In the Link Dependency Group ID section of the page, use the Group ID menu to select the
Group ID for which you want to display or configure data.
The range for Group ID is 1 to 16.
7. T
o make changes, do the following:
• Click the Clear
button to clear all interfaces from the specified group.
• Click the Update button to refresh the page with the latest information on the switch.
8. Click the Apply button.
Your settings are saved.
9. In the Link Dependency Interface Configuration section of the page, select which interfaces
are displayed on the page:
• Use LAG to display LAGs only.