NETGEAR M4300 - Configure Green Ethernet Local and Remote Devices

Configure System Information
84
M4300 Series and M4300-96X Fully Managed Switches User Manual
4. Click the Login button.
The System Information page displays.
5. Select System > Management > Green Ethernet > Green Ethernet Interface
Configuration.
6. Use one of the following methods to select an interface:
• In the Go To Interface field, enter the interface in the unit/slot/port format and click on
the
Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure
7. Use the Auto Power Down mode selection to enable or disable this option.
The factory default is Enable. When the port link is down, the PHY automatically goes
down for a short period of time, and then wakes up to check link pulses.
This allows the
switch to perform autonegotiation and save power consumption when no link partner is
present.
8. Use the EEE mode
menu to Enable or Disable this option.
The factory default is Disable. IF the EEE mode is not supported, then N/A is displayed.
9. Click the Apply button.
Your settings are saved.
Configure Green Ethernet Local and Remote Devices
 To configure green Ethernet local and remote devices:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.