Configure Switching Information
192
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. In the Group ID list, select the protocol-based VLAN group ID.
7. Select port numbers (1, 2, 3, and so on) to select ports to add to this protocol-based VLAN
group.
An interface can belong to only one group for a given protocol. If you already added a port
to a group for IP
, you cannot add it to another group that also includes IP
, although you
can add it to a new group for IPX.
8. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Configure an IP Subnet-Based VLAN
IP subnet-to-VLAN mapping is defined by configuring an entry in the IP Subnet to VLAN
table. An entry is specified through a source IP address, network mask, and the desired
VLAN ID. The IP subnet-to-VLAN configurations are shared across all ports of the device.
To add or delete an IP subnet-based VLAN:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
Table 68. Protocol-Based VLAN Group Membership
Field Description
Group Name This field identifies the name for the protocol-based VLAN that you
selected. It can be up to 32 alphanumeric characters long, including
blanks.
Current Members This button can be click to show the current numbers in the selected
protocol-based VLAN group.
To Next Page
Loading...
