Configure System Information
119
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the Interface with the information to view or configure.
You take one of the following actions:
• In the Go To Interface field, enter the interface in unit/slot/port format and c
lick the Go
button. The entry corresponding to the specified interface is selected.
• Select the check box from the list of Interfaces configured for DHCPv6 Relay
functionality.
7. In the Admin mode
field, specify the DHCPv6 mode, either Enable or Disable, to configure
DHCPv6 Relay functionality.
The default is Disable. DHCPv6 server and DHCPv6 relay functions are mutually
exclusive.
8. From the
Relay Interface list, select an interface to reach a relay server.
9. In the
Destination IP Address
, specify an IPv6 address to reach a relay server.
10. In the Remote ID field, specify the relay agent information option.
The remote ID is derived from the DHCPv6 server DUID and the relay interface number,
or it can be specified as a user-defined string.
11. Click the Apply button.
Your settings are saved.
Configure Power over Ethernet
Note: Power over Ethernet (PoE) is supported on models M4300-28G-POE+,
M4300-52G-POE+, and M4300-96X. The latter model requires one or
more APM408 port cards.
Configure Basic PoE Settings
To configure basic PoE settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > PoE > Basic > PoE Configuration.
To Next Page
Loading...
Need help?
General
