Configure System Information
141
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure LLDP-MED Global Settings
You can specify LLDP-MED parameters that are applied to the switch.
To configure LLDP-MED global settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > LLDP > LLDP-MED > Global Configuration.
6. In the Fast Start Repeat Count field, enter the number of LLDP PDUs that are transmitted
when the protocol is enabled.
The range is from (1 to 10). Default value of fast repeat count is 3.
The Device Class field specifies local device's MED classification.
There are four
dif
ferent kinds of devices, three of them represent the actual end points (classified as
Class I Generic [IP Communication Controller and so on], Class II Media [Conference
Bridge and so on], Class III Communication [IP Telephone and so on]). The fourth device
is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1
Bridge, IEEE 802.11 Wireless Access Point and so on.
7. Click the Apply button.
Your settings are saved.
MAC Address The MAC address associated with the remote system.
System Name Specifies model name of the remote device.
Remote Port ID The port component associated with the remote system.
Table 48. LLDP Remote Device Inventory (continued)
Field Description
To Next Page
Loading...
