OSPF and OSPFv3
347
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure OSPF
Configure Basic OSPF Settings
To configure basic OSPF settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing > OSPF > Basic > OSPF Configuration.
6. Select the
Admin Mode Disable
or Enable radio button.
If you select Enable, OSPF is activated for the switch. By default, OSPF is enabled. You
must configure a router ID before OSPF can become operational. Use the IP
Configuration page to configure a router ID or issue the config router id CLI
command. For more information, see Configure the Routing IP Settings on page 291.
The Router ID displays the 32-bit integer in dotted-decimal format that uniquely identifies
the router within the autonomous system (AS).
To change the router ID, you must first disable OSPF. After you set the new router ID, you
must reenable OSPF for the change to take effect.
The default value is 0.0.0.0, although
this is not a valid router ID.
7. Click the Apply button.
Your settings are saved.
To Next Page
Loading...
