NETGEAR M4300 - Configure Ipv6 Rules

Manage Device Security
608
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the nonconfigurable information displayed on the page.
Configure IPv6 Rules
Use these pages to display the rules for the IPv6 access control lists, which are created using
the IPv6 Access Control List Configuration page. By default, no specific value is in effect for
any of the IPv6 ACL rules.
 Configure ACL IPv6 rules:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security
> ACL
> Advanced > IPv6 Rules.
If no rules exists, the IPv6 ACL Rule Table shows the message No rules have been
configured for this ACL
. If one or more rule exists for the ACL, the rules display in the
IPv6 ACL Rule Table.
6. From the ACL Name menu, select the IPv6 ACL for which you want to add or a change a
rule.
Table 214. IPv6 ACL
Field Description
Current Number of ACL The current number of the IP ACLs configured on the switch.
Maximum ACL The maximum number of IP ACLs that can be configured on the switch,
depending on the hardware.
Rules The number of the rules associated with the IP ACL.
Type The type is IPv6 ACL.