Monitor the System
647
M4300 Series and M4300-96X Fully Managed Switches User Manual
9. Click the Apply button.
Your settings are saved.
Traffic of the selected interfaces is sent to the probe port.
The Status field indicates the interface status.
Configure the RSPAN Destination Switch
To configure the RSPAN destination switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Monitoring > Mirroring > RSP
AN Destination Switch Configuration
.
6. From the Session ID list, select the session ID.
7. Select the
Admin Mode T
rue (enabled) or False (disabled) radio button for the selected
session.
When a particular session is enabled, any traffic entering or leaving the source ports of
the session is copied (mirrored) onto the corresponding destination port or a remote
switched port analyzer (RSPAN) VLAN. By default, the
Admin mode is disabled.
8. Select the RSPAN Source VLAN from the list of available VLAN IDs.
9. Select the
RSPAN Destination VLAN
from the list of destination interfaces.
10. Configure the Filter Type
.
To Next Page
