NETGEAR M4300 - Page 646

Monitor the System
646
M4300 Series and M4300-96X Fully Managed Switches User Manual
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Monitoring > Mirroring > RSP
AN Source Switch Configuration.
6. Use one of the following methods to display available interfaces on the page:
• Select a Unit ID (
1, 2, 3) to display a list of physical ports for the selected unit.
• Select LAG to display LAGs only.
• Select
CPU to display CPUs only.
• Select
VLAN to display a list of available VLAN IDs.
• Select All to display all physical ports, LAGs, CPUs, and VLANs.
7. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the
Go button.
• Next to the Interface column, select the check box for the interface that you want to
use as the source, or select multiple check boxes to use all selected interfaces as
sources.
8. Select from the Direction list to specify the direction of the traffic to be mirrored from the
configured mirrored ports.
If the value is not configured, None is displayed.
The default value is None.
• None.
The value is not configured.
• Tx and Rx
. Monitor transmitted and received packets.
• Tx. Monitor transmitted packets only
.
• Rx
. Monitor received packets only.