NETGEAR M4300 - Configure UDP Relay Interface Settings

Configure System Information
108
M4300 Series and M4300-96X Fully Managed Switches User Manual
Your settings are saved.
The Hit Count field displays the number of UDP packets that are detected on the UDP
port.
Configure UDP Relay Interface Settings
 To configure UDP Relay Interface settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Services > UDP Relay > UDP Relay Interface Configuration.
6. Use Interface to select an Interface to be enabled for the UDP Relay
.
7. Use Server Address to specify the UDP Relay Server Address in x.x.x.x format.
8. Use UDP Port to specify UDP Destination Port.
The following ports are supported:
• DefaultSet
. Relay UDP port 0 packets.
This is specified if no UDP port is selected
when creating a Relay server
.
• dhcp. Relay DHCP (UDP port 67) packets.
• domain. Relay DNS (UDP port 53) packets.
• isakmp. Relay ISAKMP (UDP port 500) packets.
• mobile-ip. Relay Mobile IP (UDP port 434) packets
• nameserver. Relay IEN-1
16 Name Service (UDP port 42) packets
• netbios-dgm
. Relay NetBIOS Datagram Server (UDP port 138) packets
• netbios-ns. Relay NetBIOS Name Server (UDP port 137) packets
• ntp. Relay network time protocol (UDP port 123) packets.