NETGEAR M4300 User Manual

Routing
303
M4300 Series and M4300-96X Fully Managed Switches User Manual
17. Use Bandwidth (kbps) to specify the configured bandwidth on this interface.
This parameter communicates the speed of the interface to higher level protocols. OSPF
uses bandwidth to compute link cost. The valid range is 1 to 10000000.
18. Use ICMP Destination Unreachables
to specify the mode of sending ICMP destination
unreachables on this interface.
If this is Disabled then this interface does not send ICMP destination unreachables. By
default destination unreachables mode is enabled.
19. Use ICMP Redirects to enable or disable ICMP redirects mode.
The router sends an ICMP redirect on an interface only if redirects are enabled both
globally and on the interface. By default ICMP redirects mode is enabled.
20. Use IP MTU to specify the maximum size of IP packets sent on an interface.
The valid range is 68 bytes to the link MTU. The default value is 0. A value of 0 indicates
that the IP MTU is unconfigured. When the IP MTU is unconfigured, the router uses the
link MTU as the IP MTU.
The IP MTU is the maximum frame size minus the length of the
Layer 2 header
.
21. To delete the IP address from the selected interface, click the Delete button.
22. Click the Apply
button.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
Configure the Secondary IP Address
 To configure the secondary IP address:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
Table 108. IP Interface Configuration
Field Description
VLAN ID The VLAN ID for the interface.
OSPF Admin Mode Displays the OSPF admin mode of the interface. The default value is
Disable.
Link State The state of the specified interface is either Active or Inactive. An
interface is considered active if it the link is up and it is in forwarding
state.
Routing Interface Status Indicates whether the link status is up or down.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)