NETGEAR M4300 - Configure an RSPAN Source Interface

Monitor the System
645
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the Session ID number from the list.
7. Select the Admin Mode T
rue (enabled) or False (disabled) radio button for the selected
session.
When a particular session is enabled, any traffic entering or leaving the source ports of
the session is copied (mirrored) onto the corresponding destination port or a remote
switched port analyzer (RSPAN) VLAN. By default,
Admin mode is False (disabled).
8. Select the RSPAN Destination VLAN
from the list of available VLAN IDs.
9. Select the RSPAN Reflector Port from the list of reflector port interfaces.
10. Select from the
Filter Type list to configure IP or MAC
ACLs that can mirror traffic that
matches a permit rule.
Possible values are as follows:
• None.
• IP ACL. Configure IP
ACL.
• MAC ACL. Configure MAC ACL.
1
1. Enter the Filter Name, if a filter is configured for the session.
12. Click the Apply button.
Your settings are saved.
Configure an RSPAN Source Interface
 To configure an RSPAN source interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.