NETGEAR M4300 - Configure an IP ACL

Manage Device Security
597
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the information displayed in the MAC Binding Table.
Configure an IP ACL
An IP or IPv6 ACL consists of a set of rules that are matched sequentially against a packet.
When a packet meets the match criteria of a rule, the specified rule action (Permit/Deny) is
taken, and the additional rules are not checked for a match. You must specify the interfaces
to which an IP ACL applies, as well as whether it applies to inbound or outbound traffic. Rules
for the IP ACL are specified or created using the IPv6 ACL Rule Configuration page.
 To configure an IP ACL:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security >
ACL >
Advanced > IP ACL.
Table 213. MAC Binding Table
Field Description
Interface The interface of the ACL assigned.
Direction The selected packet filtering direction for the ACL.
ACL Type The type of ACL assigned to selected interface and direction.
ACL ID The ACL name identifying the ACL assigned to selected interface and
direction.
Sequence Number The sequence number signifying the order of the specified ACL relative
to other
ACLs assigned to selected interface and direction.