NETGEAR M4300 - Configure Virtual Router Redundancy Protocol; Configure Global VRRP Settings

Routing
338
M4300 Series and M4300-96X Fully Managed Switches User Manual
12. Use Preference Level to specify the preference level of the router as a default router
relative to other routers on the same subnet.
Higher numbered addresses are preferred. You must enter an integer.
13. Click the Apply button.
Your settings are saved.
Configure Virtual Router Redundancy Protocol
Configure Global VRRP Settings
 To configure the global VRRP settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing > VRRP > Basic > VRRP Configuration.
6. In the Global Configuration Admin Mode field, set the administrative status of VRRP in the
router by selecting the Enable or Disable radio button.
By default, VRRP is disabled.
7. Select the VRID.
The VRID field is configurable only if you are creating a new virtual router
.
The valid values are 1 to 255.
8. Select the unit/slot/port for the new virtual router from the Interface
menu.
9. In the Primary IP
Address
field, enter the primary IP address of the virtual router.