Manage Device Security
500
M4300 Series and M4300-96X Fully Managed Switches User Manual
• Routing loopback interface. The primary IP address of a routing loopback interface is
used as the source address.
• Service port. The management port source IP is used as the source address.
By default VLAN 1 is used as source interface. When the None value is displayed, it
means that the configured routing interface has become nonrouting.
9. Click the Apply
button.
Your settings are saved.
Configure TACACS Server Settings
You can configure up to five TACACS servers with which the switch can communicate.
To configure TACACS server settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security > Management Security> T
ACACS > T
ACACS Server Configuration.
6. Use TACACS Server to configure the TACACS server IP address.
7. Use Priority to specify the order in which the T
ACACS servers are used.
The valid range is 0–65535.
8. Use Port to specify the authentication port. It must be within the range 0–65535.
9. Use Key String to specify the authentication and encryption key for
T
ACACS
communications between the device and the TACACS server.
The valid range is 0–128. The key must match the key used on the TACACS server.
10. Use Connection Timeout to specify the amount of time that passes before the connection
between the device and the
TACACS server time-out.
The range is 1–30.
To Next Page
Loading...
