Multicast Routing
455
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the nonconfigurable information that is displayed.
Configure IPv6 Multicast Static Routes
To configure IPv6 multicast static routes settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> IPv6 Multicast > Static Routes Configuration.
Table 178. IPv6 Multicast MLD Proxy Membership
Field Description
Proxy Interface The interface on which the MLD proxy is enabled.
Group IP The IPv6 multicast group address.
Source Hosts Source addresses that are members of this multicast address.
Last Reporter The IPv6 address of the source of the last membership report received for
the IPv6 multicast group address on the MLD proxy interface.
Up Time The time elapsed since this entry was created.
Expiry Time The expiry time interval against each source address that is a member of
this multicast group.
This is the amount of time after which the specified
source entry is aged out.
State The state of the host entry
. A host can be in one of the following states:
• Non-member state. Does not belong to the group on the interface.
• Delaying member state. Host belongs to the group on the interface and
report timer running.
The report timer is used to send out the reports.
• Idle member state. Host belongs to the group on the interface and no
report timer is running.
Filter Mode The group filter mode (Include/Exclude/None) for the specified group on the
MLD proxy interface. Possible modes are as follows:
• Include
• Exclude
• None
Number of Sources The number of source hosts present in the selected multicast group.
To Next Page
Loading...
