NETGEAR M4300 - Change the Settings for an Existing Stack Member

Stacking
167
M4300 Series and M4300-96X Fully Managed Switches User Manual
Change the Settings for an Existing Stack Member
 To change the settings for an existing stack member:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Stacking > Stack Configuration.
The Stack Configuration page displays.
6. Select the check box next to the stack member to configure.
7. If desired, specify a new unit ID for the stack member in the Change to Switch ID field.
The renumbering process causes the unit to reload.
8. Specify the switch type, priority
, or management status from the available fields.
9. Click the Apply
button.
The changes to the stack member are saved.
Note: If you configured a new unit number for an existing stack member, you
are asked to confirm the change. Click the OK button to continue or
click the Cancel button to retain the original settings.
10. To make other changes, do the following:
• To remove the selected unit from the stack, click the Delete button.
• To update the page with the latest information from the switch, click the Refresh
button.
Note: If you are adding or removing a dummy unit with PoE for
preconfiguration, you must log in again to an actual web session to
apply changes and observe relevant PoE web pages.
1
1. If you made any changes, click the Apply button.
Your settings are saved.