NETGEAR M4300 User Manual

Stacking
168
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the nonconfigurable Stack Configuration fields.
The following table describes the nonconfigurable Stack Status information that is displayed.
Table 58. Stack Configuration
Field Description
Hardware Management
Preference
The hardware management preference of the switch. The hardware
management preference can be disabled or unassigned.
Standby Status Identifies the switch that is configured as the standby unit. The possible
values are as follows:
• Cfg Standby. Indicates that the unit is configured as the standby unit.
The unit configured as the standby switch becomes the stack manager if
the current manager fails.
• Opr Standby. Indicates that this unit is operating as the standby unit
and the configured standby unit is not part of the stack.
• None.
The switch is not configured as the standby unit.
Switch Status The status of the selected unit.
The possible values are as follows:
• OK. The
unit
is connected and works properly.
• Unsupported. The type of inserted unit is not supported.
• Code Mismatch. The firmware version is not identical to the master or
management unit.
• Config Mismatch
.
The inserted device type is dif
ferent from the
configured devices.
• Not Present.
The unit is not connected.
• SDM Mismatch
. The SDM
template does not match.
• Updating Code. A firmware
update is in progress.
• STM Mismatch. The STM
template does not match.
Table 59. Stack Status nonconfigurable fields
Field Description
Hardware Management
Preference
The hardware management preference of the switch, which can be
disabled or unassigned.
Standby Status Identifies the switch that is configured as the standby unit:
• Cfg Standby
. The
unit is configured as the standby unit. The unit
configured as the standby switch becomes the stack manager if
the current manager fails.
• Opr Standby
.
This unit is operating as the standby unit and the
configured standby Unit is not part of the stack.
• None.
The switch is not configured as the standby unit.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)