NETGEAR M4300 - View the NSF OSPF Summary

OSPF and OSPFv3
376
M4300 Series and M4300-96X Fully Managed Switches User Manual
10. Set the Tag field in routes redistributed.
This field displays the tag if the source was preconfigured; otherwise, the tag is 0 and can
be modified. The valid values are 0 to 4294967295.
1
1. From the Subnets list, select whether the subnetted routes will be redistributed (Enable) or
not (Disable).
12. In the Distribute List field, set the access list that filters the routes to be redistributed by the
destination protocol.
Only permitted routes are redistributed. If this command refers to a nonexistent access
list, all routes are permitted.
The valid values for access list IDs are 1 to 199.
When used for route filtering, the only fields in an access list that get used are as follows:
• Source IP address and netmask
• Destination IP address and netmask
• Action (permit or deny)
All other fields (source and destination port, precedence,
ToS, and so on) are ignored.
The source IP address is compared to the destination IP address of the route. The source
IP netmask in the access list rule is treated as a wildcard mask, indicating which bits in
the source IP address must match the destination address of the route.
Note: A 1 in the mask indicates a do not care in the corresponding address bit.
When an access list rule includes a destination IP address and netmask (an extended
access list), the destination IP address is compared to the network mask of the
destination of the route. The destination netmask in the access list serves as a wildcard
mask, indicating which bits in the route's destination mask are significant for the filtering
operation.
13. Click the Apply
button.
Your settings are saved.
View the NSF OSPF Summary
You can view the NSF OSPF summary. The allowable values for each field are displayed
next to the field. If any invalid values are entered, an alert message is displayed with the list
of all the valid values.
 To configure the NSF OSPF summary:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.