NETGEAR M4300 - Configure IP ACL Interface Bindings

Manage Device Security
613
M4300 Series and M4300-96X Fully Managed Switches User Manual
This option is not valid for rules that match L4 information such as TCP port number,
because that information is carried in the initial packet.
• Flow Label. The Flow Label field is enabled only if selection from the Protocol Type
menu is ICMPv6. The flow label is 20-bit number that is unique to an IPv6 packet and
that is used by end stations to signify quality-of-service handling in routers. The flow
label can specified within the range 0 to 1048575.
• IPv6 DSCP Service. Specify the IP Dif
fServ Code Point (DSCP) field.
This is an
optional configuration.
The DSCP is defined as the high-order six bits of the service type octet in the IPv6
header. Enter an integer from 0 to 63. To select the IPv6 DSCP, select one of the
DSCP keywords. To specify a numeric value, select Other and enter the numeric
value of the DSCP.
• Rate Limit Conform Data Rate. Specify the conforming data rate of IPv6 ACL rule.
V
alid values are 1 to 4294967295 in Kbps.
• Rate Limit Burst Size. Specify the burst size of the IPv6 ACL rule. V
alid values are 1
to 128 in Kbytes.
• Time Range. Specify the name of the time range that you want to associate with the
IPv6 ACL
rule.
9. Click the Apply button.
Your settings are saved.
The Rule Status field displays whether the
ACL rule is active or inactive. Blank means
that no timer schedules are assigned to the rule.
Configure IP ACL Interface Bindings
When an ACL is bound to an interface, all the rules that are defined are applied to the
selected interface. You can assign ACL lists to ACL priorities and interfaces.
 To configure IP ACL interface bindings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security >
ACL >
Advanced > IP Binding Configuration.