NETGEAR M4300 User Manual

Manage Device Security
532
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure 802.1X Settings
You can enable or disable 802.1X access control on the system.
 To configure 802.1X settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security > Port
Authentication >
Advanced > 802.1X Configuration.
6. Select the Administrative Mode Disable or Enable radio button.
The default value is Disable.
7. Select the VLAN Assignment Mode
Disable or Enable radio button.
The default value is Disable.
8. Select the EAPOL Flood Mode Disable or Enable radio button.
The default value is Disable.
9. Use Dynamic VLAN Creation Mode to select Disable or Enable.
The default value is Disable.
10. Use Monitor Mode to select Disable or Enable.
The default value is Disable. The feature monitors the dot1x authentication process and
helps in diagnosis of the authentication failure cases.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)