NETGEAR M4300 User Manual

Multicast Routing
440
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. In the SSM Group Address field, enter the source-specific multicast group IP address.
7. In the SSM Group Mask field, enter the source-specific multicast group IP address
mask.
8. Click the Add button.
The source-specific group is added.
Configure the IPv6 PIM Interface
 To configure the IPv6 PIM interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> IPv6 Multicast > IPv6 PIM > Interface Configuration.
6. Use one of the following methods to select an interface:
• In the Go To Interface field, enter the interface in the unit/slot/port format and click on
the
Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure.
7. In the Admin Mode field, select Enable or Disable.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)