NETGEAR M4300 - Configure SNMP V1;V2 Trap Flags

Configure System Information
129
M4300 Series and M4300-96X Fully Managed Switches User Manual
9. Click the Apply button.
Your settings are saved.
Configure SNMP V1/V2 Trap Flags
You can enable or disable traps. When the condition identified by an active trap is
encountered by the switch, a trap message is sent to any enabled SNMP Trap Receivers,
and a message is written to the trap log.
 To configure the trap flags:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > SNMP > SNMP V1/V2 > T
rap Flags
.