NETGEAR M4300 User Manual

Routing
306
M4300 Series and M4300-96X Fully Managed Switches User Manual
This value controls the ICMP error packets. The default burst size is 100 packets. When
the burst interval is 0, then configuring this field is not a valid operation. The valid burst
size is 1 to 200.
10. Click the Apply button.
Your settings are saved.
View the IPv6 Route Table
 To view the IPv6 Route Table:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> IPv6 > Basic > Route T
able
.
6. In the Routes Displayed list, select from the following:
• All Routes. Shows all active IPv6 routes.
• Best Routes Only. Shows only the best active routes.
• Configured Routes Only. Shows the routes configured by the user.
7. To refresh the page with the latest information on the switch, click the Update
button.
The following table describes the nonconfigurable information that is displayed.
Table 110. IPv6 Route Table
Field Description
Number of Routes The total number of active routes in the route table.
IPv6 Prefix The network prefix for the active route.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)