Configure Switching Information
221
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure MST Settings
You can configure Multiple Spanning Tree (MST) on the switch.
To configure an MST instance:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching > STP >
Advanced > MST Configuration.
Topology Change Acknowledge Identifies whether the topology change acknowledgement flag is set for
the next BPDU to be transmitted for this port. It is either True or False.
Edge port Indicates whether the port is enabled as an edge port. It takes the value
Enabled or Disabled.
Point-to-point MAC Derived value of the point-to-point status.
CST Regional Root Bridge Identifier of the CST Regional Root. It is made up using the
bridge priority and the base MAC address of the bridge.
CST Path Cost Path Cost to the CST Regional Root.
Port Up Time Since Counters Last
Cleared
Time since the counters were last cleared, displayed in Days, Hours,
Minutes, and Seconds.
Loop Inconsistent State This parameter identifies whether the port is in loop inconsistent state
or not.
Transitions Into Loop Inconsistent
State
The number of times this interface transitioned into loop inconsistent
state.
Transitions Out Of Loop
Inconsistent State
The number of times this interface transitioned out of loop inconsistent
state.
Table 77. CST Port Status (continued)
Field Description
To Next Page
Loading...
