Configure Switching Information
187
M4300 Series and M4300-96X Fully Managed Switches User Manual
The following table describes the nonconfigurable information displayed on the page.
Configure Port PVID Settings
You can assign a port VLAN ID (PVID) to an interface. There are certain requirements for a
PVID:
• You must define a PVID for all ports.
• If no other value is specified, the default VLAN PVID is used.
• T
o change the port’s default PVID, you must first create a VLAN that includes the port as
a member
.
• Use the Port VLAN ID (PVID) Configuration page to configure a virtual LAN on a port.
To configure PVID settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching> VLAN >
Advanced > Port PVID Configuration
.
Table 66. VLAN Status
Field Definition
VLAN ID The VLAN identifier (VID) of the VLAN. The range of the VLAN ID is 1
to 4093.
VLAN Name The name of the VLAN. VLAN ID 1 is always named `Default`.
VLAN Type The VLAN type:
• Default (VLAN ID = 1).
Always present
• Static
. A VLAN
that you configured
• Dynamic. A VLAN created by GVRP registration that you did not
convert to static, and that GVRP can therefore remove
Routing Interface The interface associated with the VLAN, in the case that VLAN routing
is configured for this VLAN.
Member Ports The ports that are included in the VLAN.
To Next Page
Loading...
