Configure Switching Information
273
M4300 Series and M4300-96X Fully Managed Switches User Manual
other nodes require egress traffic to be transmitted with a specific VLAN ID. With the use
of MVRP on both ingress and egress, no manual VLAN configuration is required to pass
tagged traffic through the network.
Note: MRP framework must be available and enabled in all intermediate
devices to ensure that the propagation of the attributes occurs
throughout the network.
With MRP, network attributes are declared, registered, withdrawn, and removed
completely dynamically without any user intervention. This dynamic nature is especially
useful in networks where the following is true:
- Network attributes are likely to change frequently, requiring reconfiguration of the
intermediate devices.
- Recipients of these attributes frequently increase or decrease in number.
- Each of these changes without a dynamic self-adjusting framework would require
constant attention from the network administrator.
Configure Global MRP Settings
You can configure global MRP settings for the switch.
To configure global MRP settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching > MRP > Basic > MRP Configuration.
To Next Page
Loading...
Need help?
General
