NETGEAR M4300 - Configure Global Cos Settings

Configure Quality of Service
459
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure Global CoS Settings
 To configure global CoS settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select QoS> CoS > Basic > CoS Configuration.
Note: You can also navigate to this page by selecting QoS >
CoS >
Advanced > CoS Configuration.
6. Use Global to specify all CoS configurable interfaces.
The option Global represents the most recent global configuration settings.
7. Use Interface to specify CoS configuration settings based per-interface.
8. Use Global Trust Mode to specify whether to trust a particular packet marking at ingress.
Global
Trust Mode can be one of the following:
• untrusted
• trust dot1p
• trust ip-dscp
The default value is trust dot1p.
9. Use Interface T
rust Mode to specify whether to trust a particular packet marking at ingress.
Interface
Trust mode can be one of the following:
• untrusted
• trust dot1p
• trust ip-dscp