NETGEAR M4300 - Configure the Ipv6 PIM Candidate Rendezvous Point

Multicast Routing
442
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. To refresh the page with the latest information on the switch, click the Update button.
The following table describes the nonconfigurable information that is displayed.
Configure the IPv6 PIM Candidate Rendezvous Point
 To configure the IPv6 PIM candidate rendezvous point:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> IPv6 Multicast > IPv6 PIM > Candidate RP Configuration.
Table 170. IPv6 PIM Neighbor
Field Description
Interface The interface on which the neighbor is displayed.
Neighbor IP The IP address of the PIM neighbor for this entry.
Up Time (hh:mm:ss) The time since this PIM neighbor (last) became a neighbor of the local
router
.
Expiry T
ime (hh:mm:ss) The minimum time remaining before this PIM neighbor is aged out.