Configure System Information
151
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure ISDP
You can configure ISDP global and interface settings.
Configure ISDP Basic Global Settings
To configure ISDP basic global settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > ISDP > Basic > Global Configuration.
6. Select the Admin mode Disable or Enable radio button.
This specifies whether the ISDP Service is enabled or disabled. The default value is
Enabled.
7. Use T
imer to specify the period of time between sending new ISDP packets.
The range is 5 to 254 seconds.
The default value is 30 seconds.
8. Use Hold Time to specify the hold time for ISDP packets that the switch transmits.
The hold time specifies how long a receiving device must store information sent in the
ISDP packet before discarding it. The range 10 to 255 seconds.
The default value is 180
seconds.
9. Select the Version 2
Advertisements Disable or Enable radio button.
To Next Page
Loading...
