Configure Switching Information
228
M4300 Series and M4300-96X Fully Managed Switches User Manual
The default value is 32768. If the value configured is not among the specified values, then
it is rounded off to the nearest valid value.
12. Click the Add button.
PVST/RPVST is enabled for the selected VLAN.
13. Click the Apply button.
Your settings are saved.
Configure the PVST Interface Settings
You can view and configure Per VLAN Spanning Tree Protocol (PVST)/Per VLAN Rapid
Spanning Tree Protocol (RPVST) Interface settings for the device.
To configure the PVST/RPVST Interface settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Switching > STP >
Advanced > PVST Interface.
24576 28672 32768 (default)
36864 40960 45056
49152 53248 57344
61440
Table 81. PVST/RPVST VLAN Configuration - VLAN Bridge Priority
To Next Page
Loading...
