Configure System Information
130
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the Authentication Disable or Enable radio button.
This enables or disables activation of authentication failure traps. The factory default is
Enable.
7. Select the Link Up/Down Disable or Enable radio button
This enables or disables activation of link status traps.The factory default is Enable.
8. Select the Multiple Users Disable or Enable radio button
This enables or disables activation of multiple user traps.The factory default is Enable.
This trap is triggered when the same user ID is logged into the switch more than once at
the same time (either through
Telnet or the serial port).
9. Select the Spanning Tree Disable
or Enable radio button.
This enables or disables activation of spanning tree traps. The factory default is Enable.
10. Select the ACL Disable or Enable radio button.
This enables or disables activation of ACL traps. The factory default is Disable.
11. Select the PoE Disable or Enable radio button.
This enables or disables activation of PoE traps. The factory default is Enable. Indicates
whether PoE traps are sent.
12. Click the Apply button.
Your settings are saved.
View the Supported MIBs
To view all the MIBs supported by the switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > SNMP > SNMP V1/V2 >Supported MIBs.
To Next Page
Loading...
Need help?
General
