NETGEAR M4300 - Configure an ACL Based on Destination MAC Address

Manage Device Security
588
M4300 Series and M4300-96X Fully Managed Switches User Manual
• ACL Based on Destination IPv4. To create an ACL based on the destination IPv4
address and IPv4 address mask.
• ACL Based on Source IPv4. T
o create an ACL based on the source IPv4 address
and IPv4 address mask.
• ACL Based on Destination IPv6. T
o create an ACL based on the destination IPv6
prefix and IPv6 prefix length.
• ACL Based on Source IPv6. T
o create an ACL based on the source IPv6 prefix and
IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port. T
o create an ACL based on the
destination IPv4 Layer 4 port number.
• ACL Based on Source IPv4 L4 Port. T
o create an ACL based on the source IPv4
Layer 4 port number.
• ACL Based on Destination IPv6 L4 Port. T
o create an ACL based on the
destination IPv6 Layer 4 port number.
• ACL Based on Source IPv6 L4 Port. T
o create an ACL based on the source IPv6
Layer 4 port number.
Note: For L4 port options, two rules are created: one for TCP and one for UDP.
7. From the Direction menu, select Inbound or Outbound.
Traffic rule applies either to inbound traffic only or to outbound traffic only.
8. From the Unit 1 and LAG switch figures onscreen, select the ports and LAGs to which the
rule must apply.
If a port or LAG is not selected, click the port or LAG to select it. If a port or LAG is
selected, click the port or LAG to clear it again.
9. Click the Apply
button.
Your settings are saved.
Configure an ACL Based on Destination MAC Address
Note: Binding ACLs to an interface fails if the system has no resources to
bind a new ACL.
 To configure a rule based on destination MAC address:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.