Manage Device Security
560
M4300 Series and M4300-96X Fully Managed Switches User Manual
If the incoming rate of DHCP packets exceeds the value of this for consecutive burst
interval seconds, the port is shut down. If this value is N/A, then burst interval has no
meaning, hence it is disabled. The default value is N/A. It can be set to value –1, which
means N/A. The range of rate limit is 0 to 300.
10. Use Burst Interval (secs) to specify the burst interval value for rate limiting purpose on this
interface.
If the rate limit is N/A, burst interval has no meaning and it is N/A. The default value is
N/A. It can be set to –1, which means N/A. The range of Burst Interval is 1 to 15.
1
1. Click the Apply button.
Your settings are saved.
Configure a Static DHCP Snooping Binding
To configure a static snooping binding:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security > Control > DHCP Snooping > Binding Configuration.
6. T
o configure a static binding, specify the following:
a. From the
Interface menu, select the interface.
b. In the MAC Address field, specify the MAC address that must be added for the
binding entry
.